In order to ensure the quality of the project, when choosing a small roller for construction, we need to choose a suitable roller, so how to choose? Choose according to the specific requirements of the project. Some projects require less compaction on the ground, while others require very compact compaction on the ground. Some require the road surface to be very flat, and some require simple suppression of the road surface. The choice of small rollers for different projects is naturally different.
Choose according to paving materials. Some pavements compact stones, some pavements compact asphalt, the mass of small road rollers, and pavements only compress some soil. These compacted objects are very different between small roller manufacturers, so the demand for small rollers is also different, so you should pay attention to this when choosing. Choose according to road grade. Some are secondary and some are lower. There is no need to use very good small and medium rollers to compress some roads that only need to reach very low levels in the country, which is very wasteful. If the small roller used does not meet the requirements and does not meet the national standards, this is not the case, small rollers, so this should be considered when selecting.
The manufacturer discussed the precautions when constructing a small roller. Small roller is a road construction equipment commonly used in engineering construction. During the construction process, we must pay attention to some issues, especially in terms of spacing, transition and commutation. To ensure accurate and safe construction: spacing. When using the rollers at the same construction site, keep the distance over 2.5 meters to avoid steering difficulties caused by collision. transition. A prominent advantage of small rollers is the ease of transition. However, long-distance transitions should be avoided, and when long-distance transitions are required, they should be carried by special vehicles. change direction. When reversing the small roller, first move the handle from the forward position to the intermediate position, then stop it in the retracted position, and vice versa. Do not pull it to a position to avoid damage to the machine due to sudden changes in driving direction.
