enLanguage
Home > News > Content

Inspection Method For Causing Non-vibration Of Road Roller

Nov 25, 2021

During the inspection, you can touch the high-pressure pipe output from the plunger pump with your hands and feel whether there is obvious pressure pulsation. If there is no obvious pressure pulsation, it means that the inclination angle of the swash plate is too small to output pressure oil. Second, the output pressure of the plunger pump is too low. When the vibrator is turned on, the main oil circuit pressure should be 20 to 25 MPa. If the system pressure is lower than 10 MPa, it means that the vibration pump is leaking seriously. The third is that the plunger and cylinder are seriously worn. The hydraulic oil return filter element can be checked. If there is a large amount of copper or iron filings in the oil return filter element, it means that the plunger and cylinder block are badly worn. Fourthly, the refueling pressure is low. The normal charge pressure should be 1.5~2.5MPa.

If it is less than 1.5MPa, the charge pressure is too low. Vibration motor failure is difficult to distinguish between a vibration pump failure and a motor failure with a pressure gauge test, which can usually only be determined by disassembling the vibration motor. The relevant transmission components of the power output end are damaged. If the relevant transmission components of the power output end are damaged, only the components can be replaced. The above is Lutai Engineering Machinery's analysis of several reasons why the vibratory roller will not suddenly vibrate during the work process. The vibration system of the vibratory roller is related to the production process and quality. We also need to maintain the maintenance work in the daily use process. Only in this way can faults be better reduced.


Send Inquiry