enLanguage
Home > Knowledge > Content

Common failures of paver 1

Apr 14, 2022

1. The hydraulic oil is overheated:

Excessive oil temperature of the hydraulic system of the paver will reduce the viscosity of the oil, increase the leakage, destroy the oil film of the lubricated part, and increase the wear of the components; at the same time, the high temperature will also make the gasket made of rubber and other materials premature Damaged due to aging. Therefore, it is very important to control the appropriate oil temperature. When the oil temperature is too high, it must be shut down for inspection, generally starting from the following aspects:


(1) Check whether the liquid level of the fuel tank is too low. Experience has shown that high oil temperature is often caused by the lack of fuel in the fuel tank, so it should be replenished in time when there is a shortage of fuel.


(2) Whether the hydraulic oil filter element and circuit are blocked.


(3) Whether the radiator is normal. If a large amount of dust adheres to the radiator, it can cause poor heat dissipation and increase the oil temperature. As the working environment of the paver is more dusty, the radiator should be cleaned up in time.


(4) Whether the quality of hydraulic oil is qualified. If the quality of the added oil is not up to standard, it will also cause the system oil temperature to be too high.


In addition, when the hydraulic system is running short of oil, it is easy to cause damage to the pump and motor. Therefore, after the oil shortage is eliminated, the operating status of the pump and motor should be checked, and the damaged parts of the pump and motor should be replaced if necessary.


Send Inquiry
Categories
Contact Us
    • Tel: 00852-56158988

    • Email: my@ymo.hk

    • Webwww.hk-myw.com

    • Add: Room S032, 2/F, The Capital 61-65 Chatham Road South, Tsim Sha Tsui, Kowloon, Hong kong.