In order to keep the tire roller in good technical condition, the following main maintenance work should be done:
(1) Each shift should check and tighten the bolts of each component, check the tire pressure, and check whether the bearing is hot.
(2) Add lubricating grease according to regulations.
(3) Check and adjust the axial clearance of the roller frequently. The normal axial clearance is 0.10~0.15mm. The adjusted axial clearance should be able to make the roller rotate freely, and there is no obvious axial channeling.
(4) In use, if the air pressure of each roller is inconsistent, the bearing is loose, the axial clearance is too large, the front wheel channel steel and fork foot deformation, the rear wheel bracket deformation, etc., it will cause the tire to be deflected. When the tire is deflected, there will be shaking or vibration of the roller, which will affect the quality of compaction. Therefore, when the roller works for 500~600h or half a year, the installation position of each roller should be changed to make the tire wear tend to be uniform.
(5) When the tire roller is running in the transition field, the tire pressure should be kept at 0.6~0.65MPa, the driving distance should not be too far, and the driving speed should comply with the provisions in the corresponding model manual.
(6) If the roller is parked for a long time, the fuselage should be erected to reduce the deformation of the tire under pressure.
(7) Frequently check and maintain the reliability of brake work.
(8) Repair or replace damaged parts according to the specific situation to ensure the normal function of the roller. The technical maintenance of the roller should be carried out in accordance with the technical maintenance requirements of the roller.
Precautions when replacing lubricating oil:
(1) The release of lubricating oil in the engine should be carried out after the engine is stopped, that is, before the oil temperature is high and the impurities in the oil are precipitated, and the oil in the oil filter is removed. After draining all the old lubricating oil from the drain hole, start the engine and run it for a few weeks, and all the old lubricating oil can be discharged.
(2) The old lubricating oil in the transmission must also be drained at high temperatures.
(3) When adding grease, all the old grease should be discharged, and the grease brand should not be changed frequently.ROAD ROLLER








