The loader's shoveling and loading and unloading operations are realized through the movement of its working device. The loader working device is composed of bucket boom, connecting rod, rocker arm and bucket oil, boom, cylinder, etc. The entire working device is hinged on the frame. The bucket is articulated with the bucket cylinder by connecting rods and rocker arms to load and unload material.
The boom is articulated with the frame and boom cylinder to lift the bucket. The bucket flips and the boom is hydraulically operated.
When the loader is operating, the working device should be able to ensure that: when the bucket cylinder is locked, the boom cylinder is lifted or lowered, the connecting rod mechanism makes the bucket translate up and down or close to translation, so as to avoid the bucket tilting and scattering materials; When the boom is in any position and the bucket rotates around the boom hinge point for unloading, the bucket tilt angle is not less than 45°, and the bucket can be automatically flattened when the boom is lowered after discharging.
Comprehensive domestic and foreign loader working device structure, there are mainly seven types, that is, according to the number of components of the connecting rod mechanism, it is divided into three-rod type, four-rod type, five-rod type, six-rod type and eight-rod type; According to whether the steering of the input and output rods is the same, it is divided into forward rotation and reverse linkage mechanism.
The bucket structure of the loader for earthmoving is made of low-carbon, wear-resistant and high-strength steel plate welding, the cutting edge is made of wear-resistant medium manganese alloy steel material, and the side cutting edge and reinforced angle plate are made of high-strength wear-resistant steel material.
There are four shapes of bucket cutters. The choice of tooth profile should consider factors such as insertion resistance, wear resistance and ease of replacement. The tooth shape is divided into sharp teeth and blunt teeth, tire loaders mostly use pointed teeth, and crawler loaders mostly use blunt teeth. The number of teeth depends on the width of the bucket, and the pitch between the teeth is generally 150-300mm.
The structure of the bucket teeth is divided into two types: integral type and split type, and small and medium-sized loaders mostly use integral type, while large loaders often use split type due to poor operating conditions and serious wear of bucket teeth. The split bucket teeth are divided into two parts: basic tooth 2 and tip 1, and only need to replace the tooth tip after wear.loader








