1, what are the aspects of daily maintenance of excavators?
All butter nozzles, slewing bearings, butter every 10 days to 15 days, butter twice every 4-8 hours at different angles, each reducer is replaced within 520 h2ours of the first work, and replaced 2-3 times a year later, the engine must be warmed up for 10-15 minutes before it can work.
2, hydraulic oil is divided into winter and summer
Winter oil is No. 32 or No. 46, summer oil No. 68 or No. 100, must be anti-wear hydraulic oil, the difference is high temperature in summer, high viscosity of hydraulic oil used, low temperature in winter, low viscosity of hydraulic oil used.
3, what parts of the excavator are easy to loosen?
The screws of the slewing bearing reducer and engine are loose, and the thread glue is required and applied, which must be tight and firm.
4. What should be done after parking?
Before turning off the fire, you must run at low speed for 10-15 minutes, first put the stick and bucket perpendicular to the ground, and the pilot valve moves a few times until the pressure in the hydraulic oil system is relieved.
5. What is the inner structure of the slewing reducer?
Slewing motor, motor holder, one shaft actuator, Samsung frame, one shaft, Samsung hoist, drive ring gear, vertical shaft.
6. What is the internal structure of the walking reducer?
Travel motor, first-stage reducer, inner ring gear, three-star frame, three-star hoist, reducer fixed frame, half shaft, drive wheel ring gear.
7. How to replace the gear oil of the rotary reducer and the walking reducer?
Put the gear oil off, add diesel and support the idle car for 5 minutes after releasing the diesel and then add gear oil, gear oil should be added double drive line No. 18, 120-9 walking reducer plus gear oil 3.5 liters each, slewing reducer plus gear oil 3.5 liters, 70-8 walking reducer plus gear oil 7 liters each, slewing reducer plus gear oil 3 liters. 85-7 wheeled front axle with gear oil, rear axle with gear oil,
8. What should I pay attention to before the operation of the wheeled excavator?
Before the wheeled excavator works, the bulldozer blade and the rear legs must be leveled, and the front steering wheel must be level with the car disc before it can work.
9. How many aspects are the comprehensive maintenance of wheeled excavators?
Regularly check the looseness of the screws of the whole vehicle, and the slewing bearing and the front and rear axle screw connection discs of the walking part are tight and firm.
10. Hydraulic cylinder, oil leakage?
The hydraulic cylinder is strictly forbidden to terminate, which will cause the early live air of the cylinder to fall off and the guide sleeve to be damaged, the sealing ring to wear, control the cylinder stroke, the sealing ring to wear normally, and replace the seal. Hydraulic oil impurities cause seal damage, filter hydraulic oil replacement
Seals.
11. How should the main pump of the excavator be maintained?
The hydraulic oil used first must be clean, in line with the seasonal use number, to ensure that the oil inlet pipeline is smooth, not allowed to enter the air, regularly clean the net or replace the filter element, the hydraulic oil is not allowed to contain water, replace the hydraulic oil according to the season, the power source pump should loosen the exhaust bolt when replacing the oil and refueling, and discharge the air.Excavator








